Finished my Auto to Manual Swap last night(2am this morning :fencelook
The spigot shaft bearing is new and so is the release bearing. The car does not struggle to go into gear.
Any Ideas? Need this sound to go away:bangdesk:
Sabretooth tiger said:I had that whine in my car, so stopped at the shops, let my mother in law out, and the whine was gone.
Sabretooth tiger said:I had that whine in my car, so stopped at the shops, let my mother in law out, and the whine was gone.
Haha haha. ... If we don't see you around here any more. We know it has been leaked to the mother in lawSabretooth tiger said:I had that whine in my car, so stopped at the shops, let my mother in law out, and the whine was gone.
Sabretooth tiger said:I had that whine in my car, so stopped at the shops, let my mother in law out, and the whine was gone.
JayDrft said:Hi Ver,
As Bruce mentioned drive it a bit, but you havent had any luck with the replacements that you have had....sorry bud.
I just wanted to ask, did you ever consider putting new box oil in before installing? Keeping in mind these cars are close on 20+ yrs old, most likely that oil was never replaced, and if it stands, it may accumulate surface rust inside and this might cause undesirable issues.
Hope you come right - i got an e30 325 box spare, if all else fails...might need slight mods, but that one didnt have any issues as far as I can recall.
Heres holding thumbs that you get sorted!