Gizmo
Banned
As some of you know I was busy with my brother's E39 525i. The number 5 piston's rings collapsed, well they were stuck in their grooves and compression was being lost after the car had warmed up. It baffled me at first and I thought it was a spark plug, coil, injector or lambda sensor as number 5 cylinder would miss-fire sometimes. After I had tried swapping all of the above there was still no luck, so the 2.5lt motor was stripped down to find the piston was damaged.
Luck had it that FordKoppie knew a guy wanting to sell a E46 330i engine, 6spd box, DME, key and EWS. The catch was that it was in a Toyota Hilux DC and the owner wanted to swap out the 3.0lt for a Lexus V8, so after a little negotiations I picked up the lot for R10k.
While I had the engine out I replaced the plastic water pipes, thermostat, water pump, main shaft seal, pulleys, belts, plugs, filters and intake piping. Cat headers were replaced with 328i headers and also I had to fit the 525i sump as the 3 series one is different. I also had to buy a 530i airbox as the MAF is larger on the 3.0lt. Anyway, with the motor fitted and buttoned up running on the 2.5lt DME it fired up for the first time today.:joy:
Just need to fit the covers back on, sort out the exhaust piping for the new headers and then take it to Budler Motorsport to chip the 2.5lt DME to run the 3.0lt perfectly.:thumbs:
Luck had it that FordKoppie knew a guy wanting to sell a E46 330i engine, 6spd box, DME, key and EWS. The catch was that it was in a Toyota Hilux DC and the owner wanted to swap out the 3.0lt for a Lexus V8, so after a little negotiations I picked up the lot for R10k.
While I had the engine out I replaced the plastic water pipes, thermostat, water pump, main shaft seal, pulleys, belts, plugs, filters and intake piping. Cat headers were replaced with 328i headers and also I had to fit the 525i sump as the 3 series one is different. I also had to buy a 530i airbox as the MAF is larger on the 3.0lt. Anyway, with the motor fitted and buttoned up running on the 2.5lt DME it fired up for the first time today.:joy:
Just need to fit the covers back on, sort out the exhaust piping for the new headers and then take it to Budler Motorsport to chip the 2.5lt DME to run the 3.0lt perfectly.:thumbs: